Red dots with direct fit

Red dots with direct fit mount straight to your Optics Ready slide—no adapter plate—so the optic sits lower, locks up tighter, and co-witness is easier to achieve. 

Applies to only certain models that come from factory with direct fit slide cut. Advantages? No plate and lower seating of red dot. Disadvantages? You are limited only to red dots with that very footprint.

Common footprints for direct fit

• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint

Setup essentials

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for slide-to-optic screws; re-check after your first range session.
• Verify screw length & pitch for your specific slide (no internal interference).

Compatibility with red dots for other Optics Ready CZs

Unless you have CZ with slide cut for a specific footprint, you shall look for Optics Ready plates here. They will allow you to install almost any red dot due to wide range of plates.

Not Optics Ready?

Your pistol can still run a red dot—use a dovetail red dot mount that replaces the rear sight (no slide milling required).