CZ P-10F [9x19] red dot mounts

CZ P-10F [9x19] red dot mounts replace the rear sight with a model-specific dovetail plate so you can add an optic to a non-Optics Ready P-10F—no milling and fully reversible.

Why mount on the P-10F?

• Keep the slide uncut: upgrade to a red dot without permanent machining or refinish work.
• Prove the setup first: experiment with optic models and positions, then swap back to irons in minutes.
• Duty-size balance: choose compact dots to preserve holster fit and handling on the full-size frame.

Footprints commonly supported

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Have a P-10 Optics Ready?

Factory OR slides use plates for a lower, more rigid interface—see Optics Ready plates. Note: on P-10 OR the only direct-fit optic is the Holosun SCS P10; all other dots need a plate.