CZ TS Czechmate red dot mounts

CZ TS Czechmate red dot mounts replace the rear sight with a model-specific dovetail adapter so you can run a micro red dot on a non-Optics Ready Czechmate—no milling and fully reversible.

Why on the Czechmate?

• Open-gun friendly: set up a slide-mounted dot for training or backup alongside your frame-mounted optic.
• No permanent work: protect the slide and finish while you test optics and positions.
• Quick revert: return to irons in minutes for rules, load testing, or resale.

Footprints commonly supported

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Model notes

The factory Czechmate often uses a frame-mounted optic; this dovetail mount is for slide-mounted micro dots. If you also run an Optics Ready CZ, use Optics Ready plates for the lowest, most rigid interface.